Help in creating a Varrregion

Tips and discussions about using OpenSim
Post Reply
Susan Snookums
Posts: 2
Joined: Sat May 02, 2015 11:31 pm
Has thanked: 0
Been thanked: 0

Help in creating a Varrregion

Post by Susan Snookums »

As well as my regions here on Kitely, I created a region also on Adreans-world on the OpenSim.

My region is a 4 x 4 and loads up with no problems at all. I created one big region with no sim lines to stop me sailing. However when I try to load up a 512 x 512 raw file, or a 512 x 512 OAR file, all that changes is the bottom SW corner of the region. Even if I hop into the next region and run another file, again only the same sim square alters. I am guessing that somehow I have missed setting something up correctly. But what?

I copied my region.ini file for you to look at in case I have done that wrong:

[sunshine]
RegionUUID = 5eec2f85-32c5-4c9e-a2e6-216538791888
Location = 9685,9946
SizeX = 512
SizeY = 512
SizeZ = 512
MaxPrims = 30000
InternalAddress = xxxxxxxxxxxx
InternalPort = 9016
AllowAlternatePorts = False
ExternalHostName = xxxxxxxxxxxx
MaptileStaticUUID = 00000000-0000-0000-0000-000000000000

(The IP Addresses are deliberately crossed out)

can anyone tell me what is wrong with that, or is there something in the OpenSim.ini that should be altered?

Susan xx
Post Reply