Page 1 of 1

Changing size and shape of prim skirt using LoopRez

Posted: Wed Dec 12, 2018 3:00 am
by Krissy Batya
Hi Everyone. New here. I was wondering if someone could tell me about changing the shape and size using Looprez for a skirt.

I know I have to change the configuration card numbers, but do I have to change the same numbers on the configuration card in the script?

Skirts have been coming out a bit jabberwonky.

Thank you,
Krissy

Re: Changing size and shape of prim skirt using LoopRez

Posted: Sat Dec 15, 2018 2:11 pm
by Krissy Batya
I'm going to answer my own question.

No, The script does not have to be changed. The configuration card over-rides the script. Genius.

So just change the configuration card.

Re: Changing size and shape of prim skirt using LoopRez

Posted: Sun Dec 16, 2018 4:05 pm
by Graham Mills
Very helpful to post an update. I did briefly look at a version of LoopRez which seemed to work OK, ie it rezzed a ring of prims, but didn't seem to offer notecard support. Thanks!

Re: Changing size and shape of prim skirt using LoopRez

Posted: Mon Dec 17, 2018 11:39 pm
by Krissy Batya
Hi Graham,
Sorry that I didn't post the link to the one I was talking about before this.But here it is.

https://www.outworldz.com/cgi/freescripts.plx?ID=1075

Graham, I'll send you a made up box on Kitely.(Don't use it. Think it would show up as my creation.)
It will have inside directions on how to make your creations as your own.
Any questions, just contact me in world on Kitely.

Hope it helps.
Krissy Batya